THREE DIMENSIONAL PRINTING TECHNOLOGY IN THE EDUCATIONAL PROCESS FOR THE DISCIPLINE «ENGINEERING GRAPHICS»
Abstract
The article provides an overview of additive technologies for SD printing. An example of the introduction and use of SD printing technologies in the educational process for the discipline «engineering graphics». The article describes the methodological and pedagogical aspects of the application of SD technologies in educational process. The possibility of application of SD printing technologies in the educational process while studying discipline «engineering graphics» in Novy Urengoy College of the Gas Industry.
About the Authors
Sergey Evgen'evitch Abramkin
Saint-Petersburg State Electrotechnical University «LETI»
Russian Federation
Russian Federation
Olesia Anatol'evna Philippova
Novy Urengoy College of the Gas Industry, Studencheskii
Russian Federation
Russian Federation
References
1. Зленко М. А., Попович А. А., Мутылина И. Н. Аддитивные технологии в машиностроении: учеб. пособие. СПб.: Изд-во СПбГПУ, 2013. - 222 с.
2. Усенков Д. Ю. 3D-печать: как это работает? // Мир 3D / 3D World. 2014. №3 (17). - С. 3-17.
3. Gibson I., Rosen D.W., Strucker B. Additive Manufacturing Technologies. Rapid Prototyping to Direct Digital Manufacturing. Springer, 2010. - 459 p.
4. Денисенко В. В. Компьютерное управление технологическим процессом, экспериментом, оборудованием. М.: Горячая линия - Телеком, 2009. - 608 с.
5. Азбука КОМПАС-График V 12. Машиностроительная конфигурация: учеб. пособие. М.: Изд-во ИТАР ТАСС, 2010. - 332 с.
Review
For citations:
Abramkin S.E., Philippova O.A. THREE DIMENSIONAL PRINTING TECHNOLOGY IN THE EDUCATIONAL PROCESS FOR THE DISCIPLINE «ENGINEERING GRAPHICS». Modern Science and Innovations. 2015;(3):28-32. (In Russ.)
Views:
56
Email this article 